Operating; Maintenance; Every Day; Periodic Maintenance - Chicago Pneumatic CP 0010 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions
Start and stop
Start the pump by connecting it to the power source
and turning the start and stop device.
Stop the pump by turning the start and stop device
and disconnecting it from the power source.

Operating

> The following must be done at the start of every
shift:
> Fill the reservoir with recommended oil.
> Check that the oil dosage functions, by holding
a piece of clean paper in front of the exhaust
air outlet. After about five seconds traces of oil
should appear on the paper. Adjust the oil
dosage if necessary; see section "Oiler
adjustment".
> Allowing liquid to freeze inside the pump can
cause damage to the pump.
> Do not run the pump dry for longer periods,
doing so will cause damage to the seals.
> If the pump has been used in corrosive or polluted
water, it must be operated in clean water for a
few minutes after use.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
12
www.CrowderSupply.com • Toll Free: 888-883-5144
♦ Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
♦ When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦ For major service to the machine, contact your
nearest authorised workshop.

Every day

Before undertaking any maintenance on the pump,
always switch off the air supply. Then disconnect
the air hose from the machine.
♦ Clean and inspect the machine and its functions
each day before the work commences.
♦ Conduct a general inspection for leaks and
damage.
♦ Check that the air inlet nipple is tightened and
that the claw coupling is free from damage.
♦ Change damaged parts immediately.
Replace damaged and worn components in good
♦
time.
Make sure that all the attached and related
♦
equipment, such as hoses, water separators, and
lubricators are properly maintained.

Periodic maintenance

Since each application differs, the frequency and
extent of maintenance is best established based upon
past performance. Keeping detailed maintenance
records of past performance, aids determining future
preventative maintenance intervals.
Periodic maintenance
Time interval, pump hour
Check Check Every
point concerns
Hoses and Leakage,
connections damage
Inlet filter Clogging,
damage
Threaded Tightness
unions
Pump, -
complete
Oiler Oil level,
function
*Grease Grease level
cavity
9800 0552 90c | Original instructions
CP 0010
Every Every
8th 40th 400th
X
X
X
X
X
X