Mounting Solenoid - Prowinch PWLD Serie Manual Del Usuario

4.4 MOUNTING SOLENOID

Find a location for the Solenoid. We recommend that the Solenoid be mounted close to the battery in a clean dry location. Make sure
the location you chose allows sufficient clearance from all metal components. Drill mounting holes if it is required. Once location is
found do not install until all wiring is completed.
Mounting Mini Switch (only PWLD4000A included)
1. The switch is usually installed on the left handlebar on ATV's. If you are installing on a UTV or SxS, you can use the supplied bracket
and hardware as the Fig. 4. This bracket can be placed in any location that is convenient for you.
2. If mounting to the handlebars of an ATV use electrical tape around the handlebar to help prevent rotation of the mount on the
handlebar. Do NOT tighten over any hoses or cables.
3. Once your switch is mounted you can route the wires back to where your contactor is located.
4. Splice the end of the red wire to an ignition (keyed) controlled power source using the supplied wire splice. You may need to use
a test light to locate a suitable wire. The wire should only have power when the key is in the ON position.
5. If mounting to the handlebars of an ATV make sure the handlebars have full range of motion and then secure the switch's cable
with the supplied cable ties.
Fig. 4
17