Control Panel; Language Selection; Operating States - Parker ATT Serie Manual De Uso

English
4.5 Stop
It is possible to stop the dryer in two different mode:
• NORMAL
• FORCED
Y
Is recommended to use the option "Normal".
Y
Use the option "Forced" only if necessary.
Mode stop "NORMAL":
Press
to enter on "Main Menu"
Select START/STOP
press Enter to confi rm
Select NORMAL START/STOP
press Enter to confi rm
Press Enter to confi rm the STOP
Y
IMPORTANT: wait for the dryer to perform the complete cycle
of regeneration, IT IS ABSOLUTELY PROHIBITED TO STOP THE
FLOW OF AIR UNTIL THE STOP OF THE DRYER.
Mode stop "FORCED".
Press
to enter on "Main Menu"
Select START/STOP
press Enter to confi rm
Select "Stop Directly"
Press Enter to confi rm
Select YES and confi rm.
After few second the value return
to "NO".
Y
IMPORTANT:
Machine ON: the machine should always work under pressure.
Machine OFF: do not allow air to fl ow into the tanks with the dessi-
cant when the machine is turned off.
- - -Main Menu - - -
START/STOP

4.6 Language selection

USER SETTINGS
SERVICE
INFORMATION
Select USER SETTINGS
Press Enter to confi rm
- - -Main Menu - - -
START/STOP
USER SETTINGS
SERVICE
Select Language
INFORMATION
Press Enter to confi rm
- On/Off Menu -
NORMAL START/STOP
STOP DIRECTLY
Using UP
select the language.
ENABLE UNIT RUNNING
Press Enter to confi rm
STOP
4.7 Precautions during commissioning and operation
!
During expansion, the air is expelled from the silencer:
- the unit is performing the step of "generating";
- risk of projection of material (small particles of dust, fragments...) and
noises.
Is required to perform the start-up wearing appropriate personal protec-
tive equipment(see table 1 para.1.4).
- - -Main Menu - - -
!
RISK CAUSED BY SUDDEN DEPRESSURIZATION!
START/STOP
USER SETTINGS
Do not remove components of the dryer or perform other manipulations
SERVICE
when the system is under pressure.
INFORMATION
Before performing any work on the dryer depressurize the system.
!
- - -Main Menu - - -
DO NOT CHANGE THE DEFAULT OF ELECTRONIC CONTROL
CARD.
START/STOP
USER SETTINGS
SERVICE
INFORMATION
- On/Off Menu -
NORMAL START/STOP
STOP DIRECTLY
ATT140-340
FORCING SYSTEM OFF
NO
- - -Main Menu - - -
START/STOP
USER SETTINGS
SERVICE
INFORMATION
- User Settings Menu -
DRYER SETTINGS
DATE/TIME
BMS
MOISTURE DRAIN
OTHER
LANGUAGE
and DOWN
LANGUAGE SELECTION
English
5 Control

5.1 Control panel

5.1.1 Display
5.1.2 Keys
KEY PHOTO FUNCTION
UP Shifts the cursor or increases the value
of a parameter
DOWN Shifts the cursor or decreases the value
of a parameter
ENTER Shifts the cursor from the parameter to
another or confi rm a parameter
PRG Enables access to the menu for selec-
ting the group of parameter
ESC Cancel an operation
ALARM Shows alarms on the display, switches
off the buzzer (if activated) and reset
alarms.
5.1.3 Isolator switch
ON

5.2 Operating states

With the ISOLATOR switch in ON you give the electrical power no the
unit.
!
the unit is powered up until the isolator switch in the "OFF" position.
Y
Do not start the compressor for more than 10 times.
4 / 14