Publicidad
Idiomas disponibles
Idiomas disponibles
-
NoCut may only be used in conjunction with chemicals in cases where express
permission has been granted by the manufacturer. Key information includes: chemi-
cals, concentration, temperature and exposure time.
-
Before use, ensure that the lifting equipment is not damaged in any way, and that
NoCut is placed correctly for its intended use.
-
16
Do not use NoCut in temperatures below - 40°C and above + 60°C.
-
When using NoCut, adhere to the professional association's regulations (German
Social Accident Insurance (DGUV) regulation 100-500) - Operating Working Equip-
ment (so far: BGR 500), and keep the NoCut Operation Manual.
3 Operating NoCut
3.1 Attaching NoCut
3.3 "Selecting the correct size" and 3.4 "Aligning the load" should also be adhered to
here. If NoCut has already been affixed to the lifting accessory in the factory, then there
is no need to attach it.
10a
To affix the NoCut
I. Insert the lifting accessory into one of the sleeve openings.
II. Pull the protective sleeve over the lifting accessory until the middle of NoCut protects
the lifting accessory from sharp-edged loads to be applied later.
Applying long NoCut sleeve protective sleeves to the lifting accessory can
potentially be difficult! In such a case, run a small strap or rope through the
protective sleeve first. Attach the end of the strap/rope to the according lifting
accessory
. Now, you can pull the lifting accessory through the protective sleeve by
10b
way of the strap/rope. Please also observe 3.3 Selection of appropriate size.
The permitted usable length of the NoCut sleeve over both strands of a
roundsling may amount to 1 metre maximum. See the envelope inside,
Fig.
11a
and
11b
.
The sharp-edged load can now be hoisted.
11
How to assemble NoCut
12
When using round slings, it must be decided in advance whether one or both round sling
cables need to be protected. Please also refer to 3.4 Aligning the load.
®
to the lifting equipment
®
sleeve
®
pad
®
Seite
EN
11
Publicidad
