Spanset NoCut Instrucciones De Uso página 16

- A non-slip underlay, such as the secutex rotation mat, and spacers
(e.g. square timbers) have to be used.
- Rolling in the coal or slippage in a transverse direction to the lifting belt must be
prevented.
- Diagonally "pulling out" a coil is to be avoided.
Rotate by 90°
15
Step 1: Protective sleeve minimum length L
2 x [height] + 2 x
H
Step 2: Lifting strap minimum length L
1.5 x protective sleeve + 2 x loop length = L lifting belt
Rotate by 180°
15
Step 1: Protective sleeve minimum length L
2 x H + 3 x [width] + 2 x supernatant 25 cm = L protective sleeve
H W
Step 2: Lifting strap minimum length L
2 x protective sleeve + 2 x loop length = L lifting belt
Please also refer to 3.4 Aligning the load.
Sharp-edged loads may only be rotated with SpanSet lifting belts.
When rotating and lifting coils, only NoCut sleeve may be used.
You will find further product information as well as the product finder on the
website at www.spanset-nocut.de.
4 Inspections, maintenance, repairs and decommissioning
NoCut must be inspected for visible defects and contaminants prior to every use. If a
defect is identified that may compromise safety, NoCut must not be used again. NoCut
must not be used if one of the following defects is identified:
Seite
EN
14
[width] + 2 x supernatant 25 cm = L protective sleeve
W