Publicidad
Idiomas disponibles
Idiomas disponibles
Interlocking systems:
I. Rectangular buckle: Guide the strap through the rectangular buckle, pull tight, and
affix with the Velcro tape, as in picture
II. Clip buckles: Close clip buckles and pull tight on strap ends, as in picture
III. Velcro fastener: Put the shorter side of the Velcro fastener tightly on the lifting
accessory and firmly close with the longer side, as in picture
The NoCut pad is now fastened and can be hoisted on the sharp-edged load.
13
In the case of increasing lengths, NoCut pads should also be secured with
additional fixing loops to prevent rotation. This is the only way to guarantee
that the lifting accessory is protected from the cutting effect of the sharp edge. The
fixing loops must not come into contact with the sharp edge, but should be positioned in
the direct vicinity of the edge. Therefore, additional loops are sewn up with according
fixing aids for orders longer than 0.75m. Fixing aids help stabilise the NoCut pad and
keep the lifting accessory from shifting.
Danger! The correct position of the NoCut bumper has to be checked before
17
the lifting process! The ends of the NoCut bumper have to extend beyond the
width of the lifting accessory evenly by at least 50 mm on both sides!
3.2 Edge radius
Edge radii ≥ 1 mm: If there are edge radii of above 1 mm, NoCut can be used in line
with this Operation Manual
Edge radii < 1 mm: In the case of edge radii < 1 mm, the hoisting procedure must
be planned and executed with great care to ensure that the lifting equipment is not
damaged. Always contact your distributor or SpanSet in such cases for technical
support before using the product.
Please consider table
The values labelled with check marks in the table
radius for which the product from the NoCut range named in the head of the
table can be used. Larger edge radii are included in the respective labelling.
Seite
EN
12
12-I
.
18
19
present on the fold-out back page.
.
12-III
refer to the smallest
19
12-II
.
.
Publicidad
