Harness Mode; Important - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

Using the Lower Anchors and Tethers for Children (LATCH)
LATCH SYSTEM ANCHOR LOCATIONS
Lower Anchors
11 in. (27.9 cm)
Tether Lower
Anchor Anchors
The Lower Anchors and Tethers for Children or LATCH,
is a system available on this child restraint that offers an
alternative to vehicle seat belt installation methods. The
figure above shows typical locations for lower anchors
and tether anchors in a vehicle. See pages 2-3 for LATCH
components on this child restraint.
Check your vehicle owner's manual to learn if it is equipped
with LATCH, the maximum weight rating for the lower
anchors, tether anchors capacities, and information on the
lower anchor locations and designated seating positions
available for use with this child restraint.
Tether anchor locations vary
from vehicle to vehicle. Check
Or
your vehicle owner's manual
and look for the tether anchor
symbol shown in the diagram to
Or
help identify where the top tether
anchor point is located in your
vehicle.
Overhang from Vehicle Seat

Harness Mode

It is important that the base of the child restraint rests
completely flat on the vehicle seat with no side overhang.
It is permissible to allow up to 3 in. (7.6 cm) of the base to
hang over the front edge of the vehicle seat. If the vehicle
seat does not allow enough of the child restraint base to
make contact, adjust the recline angle to a more upright
position. Not doing so could cause the child restraint to not
perform as intended.

IMPORTANT:

Car seat base MUST be flat on vehicle seat
and MUST be parallel to vehicle seat.
Booster Mode
Overhang is not allowed in booster mode. In booster mode,
the base of the child restraint must fit completely on the vehicle
seat.
11