CAMP Matik Manual De Instrucciones página 23

submerge the product in water. After cleaning, lubricate the visible pins of the moving parts with a silicone-based
lubricant spray. Note: cleaning and lubrication are recommended after each use in a marine environment.
REVISION
In addition to the normal inspection required before, during and after each use, this product must be inspected by a
skilled person every 12 months, starting from date the product is first used; this date and the subsequent checks must
be recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device. Check
the legibility of the product's markings.
Ÿ
In case of one of the following defects are present, the product should be withdrawn from service immediately:
Ÿ
Presence of cracks on any component,
Ÿ
Presence of permanent deformations on any component,
Ÿ
Unauthorised modification to the product (welding, drilling, etc.),
Ÿ
Corrosion that severely affects the surface state of the metal which does not disappear after slight rubbing with
emery paper,
Ÿ
Malfunction of the mechanisms of the actuating lever [4], the connecting lever [7], the movable cam [6].
Ÿ
Burrs and/or sharp edges on any surfaces that could come in contact with the rope; especially on the movable cam
[6], the fixed cam [5], the front plate [2], and the rear plate [1],
Ÿ
significant wear on any part of the device (>1mm),
Ÿ
breakage or loss of the mechanism cover [8].
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately.
Each product in the safety system can be damaged during a fall and must be always inspected before use it again. Do
not continue to use a product after a major fall because a damage may have occurred, even no external signs are
visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are made at
least once every 12 months from the date the product is first used and the results are recorded in the life sheet of the
product. The following factors can reduce the lifetime of the product: intense use, damage to components of the
product, contact with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to
22