3.3
Anatomical seat (OPTIONAL)
L
WARNING:
Risk of injury – Check that the seat is secure before use.
L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.4
Anatomical backrest (OPTIONAL)
L
WARNING:
Risk of injury – Check that the backrest is secure before use.
L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.5
Adjust the brakes
L
WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:
If you have opted for an anatomical padded seat, place it on
the tubular cross-hinge so that the seat's supports engage
equally with the cross-hinge. In the wooden base you will find
slots that are placed in the hinge's cross-pieces. To fold up the
wheelchair, remove the seat by pulling it upwards.
To use the anatomical backrest, proceed as follows:
1. Unscrew the flexible backrest.
2. Loosely screw on the brackets for the backrest.
3. Insert the backrest into the brackets from above.
4. Tighten the screws holding the brackets for the
backrest.
5. Insert and tighten the safety screws for the
backrest.
6. Add the armrests.
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
Page 15
708D
2015-03