Adjusting Of The Footrests; Length Of The Footrests; Maintenance - Vermeiren 708D Manual De Instrucciones

3.6

Adjusting of the footrests

3.6.1 Length of the footrests

L
CAUTION:
Risk of damage – Avoid that the footplates make any contact with the
ground. Keep a minimum distance from 60 mm above the ground.
4

Maintenance

For the maintenance manual of the wheelchairs refer to the Vermeiren website:
www.vermeiren.com.
3. Loosen the selflocking nut
mechanism can slide over the frame tube
4. Pull the brake mechanism over the tube
position. (the adjustments range shall be possible
between the groove on the brake montage plate)
5. Retighten the selflocking nut .
6. Check working of the brakes.
7. If necessary repeat the above steps until the brakes are
adjusted well.
Adjust the length of the footrests as follow:
1. Remove the Allen screw
of the upper part of the footrests.
2. Adjust the length of the footrest to a
comfortable length by moving the
hexagonal inner tube out or in.
3. Tighten the Allen screw
Page 16

so the brake


to the desired

on the lower end

properly.
The minimum length is when the
footrest tube changes from
hexagonal in round.
The maximum length is until the
mark in the tube (These mark is a
straight line).
708D
2015-03
.