Cleaning Your Acrylic Whirlpool; Clean Your Keypad And Remote Control; Flushing Your Whirlpool System; One-Year Limited Warranty - Usa And Canada - Kohler K-1158 Manual De Instrucciones

Ocultar thumbs Ver también para K-1158:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Your Whirlpool (cont.)
Carefully exit the bath, and open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to the Troubleshooting section of this
manual.

Cleaning Your Acrylic Whirlpool

Do not use abrasive cleansers or solvents on acrylic surfaces.
Wipe out the product with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
Purpose Cleaner, Gel Gloss
Clean
Lemon Fresh, Cinch
®
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.
Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste
wax. Do not wax areas where you walk or stand.

Clean Your Keypad and Remote Control

Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.

Flushing Your Whirlpool System

Flush your whirlpool system twice a month or more, depending upon usage. Use the following
sequence:
• Turn the jet trim rings fully clockwise to remove air induction.
• Fill the whirlpool with warm water to a level at least 2" (5.1 cm) above the highest jets, or leave
water in the whirlpool after using.
• Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of
household bleach (5% - 6% sodium hypochlorite) to the water.
• Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
• If desired, rinse the bath surfaces with water.
• Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.

One-Year Limited Warranty - USA and Canada

For the U.S.A. and Canada Only
KOHLER
plumbing fixtures, faucets and fittings are warranted to be free of defects in material and
®
workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co. inspection
discloses any such defects occurring in normal usage within one year after installation. Kohler Co. is not
responsible for removal or installation costs.
To obtain warranty service, contact Kohler Co. either through your Dealer, Plumbing Contractor, Home
Center or E-tailer, or by writing Kohler Co., Attn.: Customer Service Department, 444 Highland Drive,
Kohler, WI 53044, USA, or by calling 1-800-4-KOHLER from within the USA, 1-800-964-5590 from within
Canada and 001-877-680-1310 from within Mexico.
Implied warranties including that of merchantability and fitness for a particular purpose are expressly
limited in duration to the duration of this warranty, Kohler Co. disclaims any liability for special,
incidental or consequential damages. Some states/provinces do not allow limitations on how long an
implied warranty lasts, or the exclusion or limitation of special, incidental or consequential damages so these
Kohler Co.
(Bath and Shower only), Scrub Free
®
, Glass Plus
, or Fantastik
®
®
Mildew Stain Remover, Mr.
®
All Purpose.
®
5
All
®
1043843-5-B

Publicidad

Tabla de contenido
loading

Tabla de contenido