GiBiDi F12E Instrucciones Para Las Instalaciones página 14

14
UK
TIME PROGRAMMING
(run time, pause time)
Before proceeding with time programming, the control unit must be set for control of only one motor.
1) GATE CLOSED: set DIP5 to ON.
Press the button P1: the LED DL1 flashes twice (pressing it again, it would flash once only to indicate double swing
gate setting).
Program the times respecting the same logic described above (steps 2, 3, 5, 6, 7, 8).
FAST CLOSING FUNCTION
This function allows reducing the pause time to only 4 seconds from intervention and subsequent freeing of the
PHOTOCELLS. To enable the function, proceed as follows: during time programming (step 5) when the gate is in
pause, black out the PHOTOCELLS for at least three seconds. The flashlight starts flashing to signal that the function
has been stored. Free the PHOTOCELLS, wait for the desired pause time and finish the time programming phase as
normal. To disable the function, repeat the programming procedure without blacking out the PHOTOCELLS.
CONTROLLING THE FLASHLIGHT IN PAUSE TIME
For the flashlight to come on intermittently also during the pause time, press the second key of the remote control
(previously learned) during step 5 of time programming.
RADIO MODULE
f the radio module code AU01780 is used on the control unit, the signal transmitted is directly decoded by the control
unit which is able to decode rolling-code signals at a frequency of 433.92MHz. For self-learning of the remote
controls and complete memory reset refer to the following:
CODE LEARNING
)When powering the control unit the first time, the LED DL1 emits a brief flash.
Press the button P1: the LED DL1 comes on fixed to indicate that the receiver is ready to learn a code.
Press a key of the transmitter (Key 2 only for PEDESTRIAN START): the LED DL1 flashes once to indicate that the
code has been stored. The button P1 does not have to be pressed again to store other remote controls one after the
other. When the LED DL1 goes off, it indicates that the system has exited the learning phase and is ready to function
regularly.
TOTAL MEMORY RESET
To delete all the codes stored, press the button P1 (the LED DL1 comes on) and hold it down until the LED DL1 goes
off. When the button is released, the LED flashes once to signal that the code memory is empty.
IMPORTANT: If using another type of receiver, refer to the relevant instructions.
– single swing gate
(max. 200)
(only if using the RADIO MODULE code AU01780)
F12E