AirSep VisionAire 2 Manual Del Paciente página 128

EN
EN-2
Do not use your oxygen concentrator in the presence of
flammable gases. This can result in rapid burning causing
property damage, bodily injuries or death.
Care should be taken to prevent unit from getting wet or
allowing water to enter the unit. This can cause the unit to
malfunction or shut down, and cause an increased risk for
electrical shock or burns.
Disconnect the power cord from the electrical outlet before you
clean the unit to prevent accidental electrical shock hazards.
Only your Equipment Provider or a qualified service
technician should remove the covers or service the unit.
Do not use liquid directly on the unit. A list of undesirable
chemical agents includes but is not limited to the following:
alcohol and alcohol-based products, concentrated chlorine-
based products (ethylene chloride), and oil-based products
®
(Pine-Sol , Lestoil
plastic housing on the unit, as they can damage the unit's
plastic.
Clean the cabinet, control panel, and power cord only with a
mild household cleaner applied with a damp cloth or sponge,
and then wipe all surfaces dry. Do not allow any liquid to get
inside the device.
No modification of this equipment is allowed.
The unit should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is unavoidable, the
device should be observed to verify normal operation.
Federal (USA) law restricts this device to sale or rental by order
of a physician or other licensed health care provider.
VisionAire™ 2 and VisionAire™ 3
®
). These are NOT to be used to clean the
®
AirSep Corporation
MN157-1 rev. B