Manually Triggering The Signal; Remote Control Interface Or Printer Connection - Promax OD-405 Manual De Instrucciones

9. Press Rejection to select the frequency rejection mode.
Range
10. Press Noise Rej turn the noise rejection on or off.
Range
11. Press Previous menu to go back to the previous menu.
5.7.5.2

Manually triggering the signal

NOTE: This section describes how to manually trigger the input
signals when the oscilloscope does not capture them. It
applies to the Normal and Single trigger mode, since in the
Auto trigger mode, the oscilloscope keeps updating the
input single regardless of the trigger conditions.
Force Trigger
To acquire the input signal regardless of the trigger condition, press the
Force key. The oscilloscope captures the signals once.
Single Trigger
Press the single key to start waiting for the trigger condition. To break
out of the Single mode, press the Run/Stop key. The trigger mode changes to
the Normal mode.
5.8

Remote Control Interface or printer connection

The USB port located in the rear panel can be used to connect the
oscilloscope to a PC for a remote control or to a printer Pict Bridge compatible
(OD-411/OD-415 only).
USB connection
11-2011
LF, HF, Off
On, Off
PC/Printer end
Oscilloscope end
Speed
USER'S MANUAL. OD-405/410B/411/415
Type A, host
Type B, slave
1.1/2.0 (full speed)
Page 74