Rs232 Interface; Connecting To A Computer; Connecting To A Serial Printer; Printouts - OHAUS Defender 5000 Serie Manual De Instrucciones

EN-50

5.2 RS232 Interface

RS232 (DB9) Pin Connections:
Pin 2: Scale transmit line (TxD)
Pin 3: Scale receive line (RxD)
Pin 5: Ground signal (GND)
Pin 7: Clear to send (hardware handshake) (CTS)
Pin 8: Request to send (hardware handshake) (RTS)
Use the built-in RS-232 Port to connect either to a computer or a printer

5.3 Connecting to a Computer

Connect to the computer with a standard (straight-through) serial cable.
Use HyperTerminal or similar terminal software to test communication with the computer.
Set up HyperTerminal as follows:
Choose New Connection, "connect using" COM1 (or available COM port).
Select Baud=9600; Parity=8 None; Stop=1; Handshaking=None. Click OK.
Choose Properties/Settings, then ASCII Setup. Check boxes as illustrated:
(Send line ends...; Echo typed characters...; Wrap lines...)
Verify communication by pressing the Print button. If HyperTerminal is set up properly, the value on
the display will be displayed in the window.

5.4 Connecting to a Serial Printer

Connect the cable supplied with the printer to the scale's RS-232 port.
Make sure that the indicator and printer communication settings match.
Test communication with the printer by pressing the Print button. If the indicator and printer are set
up properly, the value on the display will be printed.

5.5 Printouts

Printout string for g, kg, lb, oz units:
Check Weighing application:
Weight Space Unit
Field
(Right
aligned)
11 1
Length
Non-Check Weighing application:
Weight
Field
(Right
aligned)
11
Length
Each field is followed by a single delimiting space (ASCII: 32).
Space Stability
(Right (?)
aligned)
5 1 1
Space Unit Space
(Right
aligned)
1 5 1
Space T/N/G/PT Space Application
(Right
aligned)
1 2 1
Stability Space
(?)
1 1
Defender 5000 Indicators
Term.
Status
(Right aligned)
6 2
T/N/G/PT Term.
(Right aligned)
2 2