Descargar Imprimir esta página

Programming The Remote Control - Genie Chainlift 2020 Manual De Operación Y Mantenimiento

Publicidad

A
CCESSORIES
C
H
Programming 1:
A
To program one Button of a Remote Control (Figure 11 and 12 ):
Locate Learn Button and Learn Indicator Light near
Terminal Block on Power Head (Figure 13).
Press and release Learn Button. Red Learn Indicator Light
will blink 2 times per second.
Press Remote Control Button once within 30 seconds.
Red Learn Indicator Light will stay lit.
Press Remote Control Button again. Red Learn Indicator
Light will go out, indicating that memory is stored.
Press again to Activate Unit.
B
Program each additional Remote using step A above.
To Erase All Remotes from Power Head Memory
A
Press and hold Learn Button on Power Head for 10 seconds or
until Learn Indicator Light goes out. Memory is erased:
Program Remotes again as needed.
To Replace Remote Control Battery
A
Push in on Battery Cover Latch at base of Remote Control.
Use coin, pen, screwdriver or any similar device.
Cover snaps open.
Replace old Battery with new compatable coin
type battery.
B
Snap Battery Cover closed.
A moving garage door may cause serious injury or death.
Keep people clear of opening while door is moving.
Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
Close the door and disconnect the Opener using the
Emergency Release Cord.
Do not use the door Opener, Remote Controls, or
Wireless Keypad.
Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
Remote Control Operation
A
Press Button on Remote Control. Garage door will move.
B
Press Button again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
C
Press Button again. Garage door will reverse.
315 Mhz
Frequency
390 Mhz
1 Button Compact Remote
w/Docking Station
Figure 11 Genie Remote Controls
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
P
ROGRAMMING THE
R
C
EMOTE
ONTROL
WARNING
Frequency Switch
Switch
3 Button Compact Remote
w/Docking Station
Remote Control Operation Continued
D
Some Remote Controls are equipped
with a flashlight. The Genie logo is
the button which operates the light.
There is a backlight under the
button. When it does not light, it
indicates the battery
needs replaced.
Flashlight Button
1 Button
3 Button
Remote
Remote
w/Flashlight
w/Flashlight
Figure 12 Genie Remote Controls
LOCATED
UNDER THE
LIGHT LENS
MORE
FORCE
Figure 13 Learn Code Button and Indicator Light.
(Located Lower Right Corner).
Frequency Switch
3 Button
Large
Remote
w/Flashlight
3
4
5
6
LEARN
INDICATOR
LIGHT
LEARN
CODE
BUTTON
11

Publicidad

Capítulos

loading