Descargar Imprimir esta página

Troubleshooting Guide - Genie Chainlift 2020 Manual De Operación Y Mantenimiento

Publicidad

T
ROUBLESHOOTING
Safe-T-Beam® System Self-Diagnostic Troubleshooting
Source (Red LED)
ON
OFF
OFF
2 BLINKS, Pause
(Repeat)
2 BLINKS, Pause
(Repeat)
3 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
G
UIDE
Sensor (Green LED)
ON
Normal operation
• Power Head not powered
OFF
• Wiring from Power Head bad
• Wiring to Source missing or bad • Check wiring
ON
• Power has been interrupted
• Beam not aligned
ON
• Beam obstructed
• Sensor defective
• Wire to Sensor missing or bad
OFF
• Sensor defective
• Sensor receiving interference
ON
• Source not sending pulses
ON
• Source defective
Possible Problem
Solution
None required
• Check breakers, fuses, plugs
• Check wiring for obvious shorts
• Remove power and reapply
• Check Source, Sensor alignment
• Check for obstruction
• Contact Customer Service
• Check wiring
• Contact Customer Service
• Determine source of interference
• Check for sunlight or another
opener on nearby door
• Contact Customer Service
• Contact Customer Service
• Contact Customer Service
15

Publicidad

Capítulos

loading