Compliance; Unpacking And Packing; Unpacking; Packing - Kinetec Spectra XL Manual De Empleo

3.

Compliance

The device Kinetec Spectra XL™ complies with the standards of Directive 93/42/EEC, and bears the EC
mark.
The device Kinetec Spectra XL™ complies with the standards in force IEC 60601-1-2 concerning the
electromagnetic compatibility of medical devices, IEC 60601-1 concerning electrical safety and IEC
60601-1-11 concerning the utilisation in home care environment.
The device Kinetec Spectra XL™ meets the requirements of the Machinery Directive No. 2006/42/EC.
4.

Unpacking and packing

4.1. Unpacking

When you unpack the machine, don't forget that you may need to pack
it up again. We recommend that you keep the packaging materials,
boxes and plastic bags.
Recommendations for plastic bags: do not put them over the head as
there is a risk of suffocation, and keep them out of the reach of children.
Be careful with small-sized pieces: they could be swallowed by a child.
Be careful with cables and wires: risk of strangulation.
Before using your machine you must move the foot plate into
its working position. (See page 14).
Your machine is ready to be connected to the power supply.
(See page 6).

4.2. Packing

To prevent any problems when the machine is
transported, only pack it using its original packaging.
- Set the leg support to 42cm
- Stop the unit at 5° of flexion.
- Move the foot plate back into its packing position.
5.

Installing the device

The device Kinetec Spectra XL™ is designed to be used in hospitals, clinics, doctors' offices or in private
homes (rental).
The machine must be installed on a flat surface that is wide enough to accommodate the entire device
plus the other leg.
We recommend using the machine with a physiotherapy table, a healthcare bed, a bed or a bench.
We do not recommend the use of an air mattress.
Kinetec Spectra XL™
EN 4/20