Electrical Connection: Safety First; Procedure To Start The Machine - Kinetec Spectra XL Manual De Empleo

7.

Electrical connection: safety first

Before connecting the device to the power supply, check that the mains voltage matches that shown on
the identification plate (100-240V~ 50/60Hz).
Connect the hand control (4).
4
IMPORTANT
To connect the power supply, only use the original cable supplied with the machine.
Check that the cables remain free around the device so that they do not get damaged.
Check that the machine is not damaged, in particular the protective housings.
8.

Procedure to start the machine

Switch on the unit (9).
The display comes on, the machine carries out a self-test and the display shows in succession
Spectra Vxx.x
Then
Movement Verify.
Then
Patient's first name
Then
30 STOP
Your Kinetec Spectra XL™ is ready to be used with the parameters from the previous session, unless you are
using a daily program (see the instruction manual for the Kinetec Data Capture™ software).
Warning: Always check the motion parameters displayed on the hand control before starting the device.
Note: Before using the device with data recording, please refer to the instruction manual for the
Kinetec Data Capture™ software. The splint can be used immediately without the USB key being
connected to a computer, or even with no USB key; in this case no data will be recorded.
Kinetec Spectra XL™
KINETEC
Please Wait
Hello
KINETEC
15 70
Connect the power supply cable (25).
9
25
EN 6/20