How To Define The Patient Tolerance? • At The Start Of A Session; How To Define The Patient Tolerance? • During The Session - Kinetec Spectra XL Manual De Empleo

9.9. How to define the patient tolerance? • At the start of a session
This function, MODULATION MODE, allows the maximum limits that a patient can tolerate to be
defined and recorded at the beginning of a session.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To select
MODULATION Mode
To select the pain level
( for flexion, for extension)
To set the pain level when reached,
immediately press
To start the session with the new movement
limits
Comments: When the maximum or minimum range of motion of the machine is reached, this
limit is recorded and the MODULATION MODE is automatically switched OFF.
9.10. How to define the patient tolerance? • During the session
This function, BYPASS Mode, allows the maximum limits that a patient can tolerate to be defined
and recorded, which allows you to work on increasing amplitude.
Beginning
The unit is running
To select
BYPASS Mode
To select the NEW pain level
To set the new pain level when reached,
immediately press
Continue the session with the new movement
limits.
Comments: When the maximum or minimum range of motion of the machine is reached, this
limit is recorded and the BYPASS Mode is automatically switched OFF.
Kinetec Spectra XL™
Keys to
press
Or
Continuous press
Or
IMPORTANT: Can be used only when the machine is RUNNING.
Keys to
press
Or
Continuous press
Or
Display
KINETEC
40 STOP 50 110
MODUL.: use +or-
40 STOP 50 110
MODUL.: use +or-
40 MANUAL 60 110
MODUL.: use +or-
40 MANUAL 60 60
KINETEC
40 STOP 55 60
Display
KINETEC
40 RUN 55 60
WARM UP
40 RUN 55 60
BYPASS: use +or-
40 RUN 55 60
BYPASS: use +or-
40 BYPASS 72 60
BYPASS: use +or-
40 BYPASS 72 72
KINETEC
40 RUN 64 72
EN
Remarks
Check if the hand control is not
locked (See page 7).
If Warm Up mode is selected, switch
OFF this mode by pressing the "Warm
Up" key.
The display indicates the keys used to
run the machine. This message is
displayed 3 seconds.
The unit begins to move as selected.
It is waiting for you to select new
limits.
The new limit of the movement is
recorded.
The angle display changes with the
current movement.
Remarks
Check if the hand control is not
locked (See page 7).
Or, if Warm Up mode is selected.
The display indicates the keys used to
run the machine. This message is
displayed 3 seconds.
The unit begins to move as selected.
It is waiting for you to select new
limits.
The new limit of the movement is
recorded.
The angle display changes with the
current movement.
10/20