Saeco Intelia Deluxe HD8904 Manual De Instrucciones página 24

English
24
The brew group cannot
be inserted.
The coffee has too little
cream or is watery.
The coffee is not hot
enough.
The machine grinds the
coffee beans, but coffee
does not come out.
The coffee grounds container is
not removed.
The machine is still in the
descaling process.
The brew group is not in the
correct position.
The grinder is set to a coarse
setting.
The brew group is dirty.
The coffee exit duct is dirty.
The coffee blend is not the
correct one.
The machine is performing its
self-adjustment.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The grind is set too fine.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The coffee exit duct is blocked.
Remove the coffee grounds container
before removing the brew group.
You cannot remove the brew group
when the descaling process is active.
First complete the descaling process
and then remove the brew group.
The brew group was not put in rest
position before it was placed back.
Make sure that the lever is in contact
with the base of the brew group and
that the hook of the brew group is in
the correct position.
Reset the machine by switching it on
and off. Place the drip tray and the
coffee grounds container back. Leave
the brew group out. Close the
maintenance door and switch the
machine on and off. Then try to
reinsert the brew group.
Adjust the grinder to a finer setting.
Clean the brew group. For thorough
cleaning, follow the monthly cleaning
procedure with the degreasing tablet.
Clean the coffee exit duct thoroughly
with the handle of the multifunctional
tool or a spoon handle.
Try another coffee blend.
Brew a few cups of coffee.
Preheat the cups by rinsing them with
hot water.
Set the temperature to high in the
menu.
Whether the milk you add is warm or
cold, it will always decrease the
temperature of the coffee to some
extent.
Adjust the grinder to a coarser setting.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.
Clean the coffee exit duct with the
handle of the multifunctional tool or a
spoon handle.