Cleaning The Solubles Circuit; (Level 2) - Faema BARCODE NEW TOUCH Uso E Instalacion

Level 1
WASHING THE SOLUBLES CIRCUIT
Functioning: At the end of each soluble product dispensing phase, the preset counter starts (from 1 to 20 minutes, OFF,
function disabled). Afterwards, the request to wash the circuit will appear.
Please follow these instructions for the washing process:
1
After the machine sends the
message.
4 Press the key PRG (29)
The following will appear on the
display:
24 29
7
The washing cycle has ended when
this message appears on the display:
WASH COMPLETED
MACHINE READY

CLEANING THE SOLUBLES CIRCUIT

2
1
Raise the dispensing nozzle (1).
. 5
Press the washing key (26)
until the
WASH" appears, as shown below:
PRESS WASH
Group Washing
Milk Washing
Soluble Washing
26
Remove the washing container.
Press the key
the wash cycle screen and the RES
(24) key to return to normal work
mode.
3
1
Place the washing container sotto il
6
message "PRESS
The washing cycle starts if the key PRG
(29)
on the group washing line, or when
the SOLUBLE WASHING option is
pressed directly on the Touch Screen.
The message below will appear on
the display:
Selection block: If the washing cycle
is not performed within 60' after the
message appears, with the
to return to
soluble circuit" function set (YES),
the machine is blocked to prevent all
soluble-based selections.
The indications above are performed in
addition to the solubles circuit washing
process described on the following
page.
24 EN
under the dispensing nozzle (1).
is pressed when the cursor is
WASHING IN PROGRESS