Coffee Circuit Cleaning Cycle - Faema BARCODE NEW TOUCH Uso E Instalacion

Level 1
These procedures are to be performed at the end of the
work day or when the machine sends a message (see
paragraph "Customer programming – Services hour menu).
When the machine sends a message, the screen displays
Please follow these instructions for the washing process:
1
After the machine sends the
message.
4 Press the key PRG (29)
The following will appear on the
display:
24 29
7
Press the key
until the machine performs
a n a u t o m a t i c w a s h i n g c y c l e
(approximately 2 minutes).
The message below will appear on
the display:
WASHING IN PROGRESS

COFFEE CIRCUIT CLEANING CYCLE

2
1
Raise the dispensing nozzle (1).
. 5
Press the washing key (26)
until the
WASH" appears, as shown below:
PRESS WASH
Group Washing
Milk Washing
Soluble Washing
26
8
The washing cycle has ended
and wait
when this message appears on
the display:
WASH COMPLETED
MACHINE READY
Remove the washing container.
Press the key
the wash cycle screen and the RES
(24) key to return to normal work
mode.
"EXECUTE WASHING GROUP", accompanied by an
acoustic signal.
The message and signal will continue until the wash cycle
is performed or up until the end of the timeout (60').
3
1
Place the washing container sotto il
6
message "PRESS
cursor is on the group washing line, or
when the GROUP WASHING option is
pressed directly on the Touch Screen.
The message below will appear on
the display:
Selection block - This occurs after 60'
of functioning from the preset time if
the washing cycle has not taken place,
with the
enabled (YES) by the installer.
to return to
21 EN
under the dispensing nozzle (1).
The washing cycle starts if the key
PRG (29) is pressed when the
START WASHING
function