Final Assembly (Qualified Specialist) - Speck pumpen BADUJET Vogue Instrucciones Para El Manejo

5.3

Final assembly (Qualified specialist)

WARNING
Injury due to suction if the suction panel is not mounted!
 It is imperative that the suction panel is mounted.
All guarantee rights and claims for compensation are rendered
invalid for damage resulting from the suction panel not being
mounted or being mounting incorrectly.
NOTICE
Only tighten the screws hand-tight. Do not use any force!
After the installation of the main housing (pre-assembly kit):
1. Glue in the cable protection hose and the hose for air supply.
(Fig. 15)
2. Position the suction housing (107) on the clamp ring. Pay
attention to the mounting position. (Fig. 16)
3. Position the nozzle housing (102.1) on the main housing (1).
4. Lead the pneumatic hoses (47) and floodlight cables through
the protective conduit (14) and seal with the cable gland (20).
5. Attach the air pipe to the air regulator (21), assembled on
site, with a clamp (8).
6. Attach the nozzle housing (102.1) to the main housing (1)
with four tapping screws (95). (Fig. 17)
7. Lead the pneumatic hoses through the openings in the
stainless steel cover (93) and fasten them to the
corresponding buttons with hose clamps (46); Light ON/OFF
left; Pump ON/OFF right. (Fig. 18)
8. Position the stainless steel cover (93) on the suction housing
(107) and attach to the nozzle housing with the screws (49).
Insert the two pneumatic buttons through the light cover
(110) in the nozzle housing and lock by turning it clockwise.
(Fig. 19)
9. By attaching the light cover (110) the stainless steel cover
(93) is also attached. Place the light cover over the ball
nozzle (54) in the nozzle housing (102.1) and attach it with
the screws (112). (Fig. 19)
10. Attach the decorative caps in the light cover as in Fig. 16.
Use the correct decorative cap for left (L) and right (R). (Fig.
20)
11. Secure the cover for the air regulator. (Fig. 21)
03|2020
Installation
EN 29