gala gar Smart Tig 310 PACDC Manual Técnico De Instrucciones página 37

Smart Tig 310 P ACDC
Pág. 37
2.7 Practical welding process management function
The machine allows users to divide the welding parameters into five groups, according to different techniques
during operation, each of which can complete a particular welding task. It undoubtedly facilitates the technical
standardization management in welding production.
2.8 High-quality MMA welding
MMA welding performance is significantly improved with excellent control algorithm: easier to ignite arc, stable
welding current, little spatter, no electrode sticking, good shaping, and adaptable to the change of length or section
of welding cable.
2.9 High-quality TIG welding
Improved digital technology for constant current ensures the low noise and a high stability of arc quality as well.
Meanwhile, the mature control algorithm provides users with a convenient and practical approach to control the
current freely. Totally 20 TIG operation modes, including the typical 2T/4T, and 4 of them are programmable, which
offers a favorable approach for user's special application.
2.10 Remote control available
The machine offers an analog remote control mode (foot control), which can realize real-time adjustment of TIG
welding current over 10m away.
2.11 Robot system for automatic welding available
The machine is provided with RS-485 communication interface, and it is easy for users to compose an automatic
welding system with other equipment with the embedded standard ModBus communication protocol. Contact our
company for a special order if necessary.
2.12 Perfect automatic recording function
All data such as cumulative startup times, cumulative running time, cumulative welding time, cumulative TIG
welding time, accumulative MMA welding time, cumulative times of alarm, cumulative times of overcurrent,
cumulative times of overheating, cumulative times of undervoltage and cumulative times of water-cooling alarm can
be calculated and stored in FLASH memory. And also, these data can be obtained through the RS-485 serial
interface, providing a basis for maintenance. Meanwhile, it is a good preliminary preparation for remote
maintenance.
2.13 Control interface for automatic welding equipment available
This machine provides torch trigger signal, current signal and fault alarm signal for connection with automatic
welding equipment. Thus, automatic welding can be obtained easily.
2.14 Wide input voltage range adaptable
Welding can be carried out under 3-phase AC 280-420V with this machine.
3. BLOCK SCHEMATIC DIAGRAM.