Parameter Setting - gala gar Smart Tig 310 PACDC Manual Técnico De Instrucciones

6—MMA parameter selecting zone
7—Foot control selecting zone
Select the foot control to control the welding current by pressing the foot control key with the LED on. The welding
current should be 30A at least (to avoid arc breaking due to overly low current) and should not be higher than the
preset current. The foot control is effective only in TIG mode.

5.5 Parameter setting

Operation hints
● Press "↓" in parameter display selecting zone to select the parameter to be displayed.
● Press "↓" in welding mode selecting zone to select welding mode (totally 6 welding modes).
● Press "←"or "→" in TIG parameter selecting zone to select parameter in TIG. (only in TIG mode)
● Press "→"in MMA parameter selecting zone to select parameter in MMA. (only in MMA mode)
● Turn the adjustment knob to set or amend the parameter currently selected.
Operation hints
The parameters having been adjusted will be autosaved in the parameter group currently used (no autosaving will
be done in the case that no operation is done after parameters are adjusted and the machine was turned off in 3s'
time). When the machine is turned on next time, the parameters in this parameter group are just the parameters
used last time. No special save key and manual saving operation is available for this machine.
Concept hints
5 parameter groups (1-5) are available for users to save the welding parameters based on welding application,
and all parameters in all the six welding modes can be saved in each parameter group. Every time when the
machine is turned on, it is under the parameter group of last time when the machine is turned off. If users do not
rechoose the parameter group, the machine will continue its working under this parameter group. Users can set
different parameters in different parameter groups and select corresponding one to weld. (Note: Parameters in all
the five parameter groups are the same and are all default when using the machine for the first time.)
5.5.1 Parameter group selecting
In standby mode, press "↓" in parameter and alarm display zone to lighten the "MEMORY" LED, and at this time,
what the digital meter displays is the No. of the parameter group being used. Turn the adjustment knob, the
parameter group No. will be changed, and you can select the desired parameter group. After selecting the
parameter group, you can repress "↓" to exit, or you can wait for about 10s till the machine return to parameter
display status automatically.
Smart Tig 310 P ACDC
1-Arc ignition current
2-Arc ignition time
3-Welding current
4-Arc force current
5-MMA parameter selecting key
Selection and adjustment of parameters
Parameter storage
Parameter group
Pág. 42