Foot Control - gala gar Smart Tig 310 PACDC Manual Técnico De Instrucciones

1) Insert the cable plug with work clamp into the "
it clockwise. Clamp the workpiece with the work clamp.
2) Insert the cable plug with TIG torch into the "
clockwise. Insert the aviation plug on the TIG torch into the 2-pin aviation socket under the sign "
panel of the machine, and tighten it clockwise. Connect the gas nozzle of TIG torch to the gas output terminal on the
front panel of the machine, and tighten it clockwise.
3) Select the proper gas hose with a proper length, and connect one end of it to the gas inlet on the back panel of
the machine, and the other end to the gas outlet of gas regulator on the cylinder. All connection should be tight
enough to avoid gas leak.
5.7.2 Operation of TIG
After making sure that all are correctly installed, close the power supply switch to start the machine. Select AC
square wave TIG, AC pulsed TIG, DC TIG or DC pulsed TIG by pressing the welding mode selecting key on the
front panel of the machine, or select welding mode such as TIG spot welding or composite waveform TIG welding
by selecting operation mode. Open the gas valve of the cylinder, adjust the gas flow to the proper value, select the
correct cooling mode, adjust all parameters to the proper value according to the relevant content in this manual,
and TIG welding can be carried out. The arc ignition mode of this machine is noncontact arc ignition. During
welding, the parameter display meter displays the welding current, and it can display the arc voltage by pressing
the key in the parameter display selecting zone.

5.7.3 Foot control

Foot control function is generally used in TIG mode:
Connect the foot control to the corresponding terminal on the front panel of machine with a special cable.

Press the foot control selecting key on the front panel of the machine to lighten the foot control LED.

Adjust the welding parameters to the proper value, and then welding can be carried out.

When welding under foot control, TIG operation mode 0 is used, and it has nothing to do with the current operation

mode setting.
Step on the foot control to ignite arc in non-contact arc ignition mode. After arc is ignited successfully, the welding

current will be controlled by the foot control. The minimum current value is 30A, while the maximum current is
the preset value.
Note: Foot control is optional. Give your requirement when placing your order if necessary.
5.7.4 Application of automatic welding
Connect the computer with the communication interface RS-485 (It is optional, and give your requirement when
placing your order if necessary.) of the machine; equip proper software; and computer-controlled automatic welding
can be carried out. The communication protocol of automatic control is available against payment with this
machine, while the computer software for automatic welding should be provided by users themselves.
5.8 Installation and operation in SMAW
5.8.1 Installation in SMAW
3) Insert the cable plug with work clamp into the "
tighten it clockwise.
4) Insert the cable plug with electrode holder into the "
tighten it clockwise.
For DC welding, the connection as mentioned above is DCEP polarity. Operator may choose DCEP/DCEN
according to workpiece and electrode application requirement. Generally, DCEP polarity is recommended for basic
electrode, while there is no special polarity requirement for acid electrode. For AC welding, there are no such
names.
Smart Tig 310 P ACDC
" socket on the front panel of the welding machine, and tighten
" socket on the front panel of the welding machine, and tighten it
" socket on the front panel of the welding machine, and
" socket on the front panel of the welding machine, and
Pág. 54
" on the front