Problem
Probable Cause
Water is leaking
Water leakage.
from the Control
Unit.
Handpiece
Tip oscillates, but
LED does not
Handpiece LED
illuminate.
turns on and off.
(Varios2 Lux)
Loss of the power
Power output is
output without
set 8 at G
operation.
14. Spare Parts
Model
Products
Water Filter Set
Water Supply
Connector
Water Filter
Spanner Wrench
(5x8) x 2 pice
Autoclavable up to max135˚C.
15. Disposing product
Consult with dealer from whom you purchased it about waste disposal.
16 . Warranty
Manufacturer warrants its products to the original purchaser against defects in material and workmanship under normal
practices of installation, use and servicing. Such expendable items as O-Ring is not covered by this warranty.
Cause
The water circuitry in the Control Unit
is damaged.
The handpiece is not connected into
the Handpiece Cord correctly.
Protection Circuit is activated.
Order code
Tip Wrench
U387040
(CR-10)
U387030
Tip Holder
U387042
Tip Cover S
Y1001301
O-Ring
13
Solution
Contact dealer.
Firmly insert the handpiece into the Handpiece
Cord inmost.
Powerful output will weaken automatically while
continuous operation is over 10min at the setting
of Maximum power at G mode. Releasing the foot
from the Foot Control. Decrease the Power less
than 5, once then increase the power again. ( Refer
to 7-5 Protection Circuit )
Model
Products
Order code
Z221076
Z221080
Z217851
D0310020080