Publicidad
Idiomas disponibles
Idiomas disponibles
HEATER INLET PIPE
HEATER OUTLET PIPE
Engine Oil Cooling
The engine as delivered comes with a liquid to liquid engine oil cooler. Engine oil is pumped thru the cooler and engine coolant is pumped thru the
cooler, to transfer the engine oil heat into the engine coolant. The engine coolant should route to the lower portion of the radiator, or inlet hose of the
coolant pump. Heat is then removed by the engine radiator. Reference the 2017 Camaro for additional parts.
COOLER HOSE
AND
ATTACHMENT
BOLT
Exhaust/Catalytic converter installation
Exhaust Manifolds
It is recommended that you use the provided exhaust manifolds or similar OEM LT Engine style Exhaust Manifolds to maintain the emission compliance
of the LT1 E-ROD.
Catalytic Converters
NOTE: It is critical that the Catalytic Converters are mounted per the instructions below. Oxygen Sensors
NOTE: It is critical that the Oxygen Sensors are mounted per the instructions below. The exhaust system MUST be properly sealed – any leak near the
sensors (upstream or downstream) can cause incorrect operation of the fuel control system. Vehicle performance and/or drivability may be affected
if sensors are not mounted as recommended or if
an exhaust leak exists. Leak check the exhaust system to ensure adequate sealing (even small leaks can affect fuel
control).
Pre-Catalysts (Front) Oxygen Sensors should be mounted in the provided locations. If bosses are not available in your installation, use the supplied
oxygen sensor bungs and place in the collector area of the exhaust system in a location that allows exhaust from all cylinders to be sampled equally. Be
sure the connectors and wiring are routed away from high heat areas. The oxygen sensors should be mounted with the sensor tip pointing between 10
degrees above horizontal and fully downward – do not mount with the tip oriented upward. Weld in the mounting bosses supplied (7/8" hole) if
required.
LT1 E-ROD Instruction Sheet
ALL INFORMATION WITHIN ABOVE
Date
BORDER TO BE PRINTED EXACTLY
20MY19
AS SHOWN ON 8.5 x 11 WHITE 16
POUND NON-BOND RECYCLABLE
03OC19
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
ATTACH TO LOWER RADIATOR HOSE
FOR PROPER COOLANT FLOW
Rev 03OC19
Revision
Auth
Init Rel – Blake Nye
NA
Rev – Blake Nye
NA
PART No.
19418603
DR
Installation Instructions
Title
LT1 E-ROD
19418603
PART No.
SHEET
7 of 69
SHEET 7 of 69
Publicidad
