Re-Adjustment Of Oil Pressure Regulator; Verificación Del Sentido De Rotación Del Eje Motor - GEA Grasso 5HP Manual De Instalación Y Mantenimiento

Compresores alternativos para refrigeración industrial
Ocultar thumbs Ver también para Grasso 5HP:
Tabla de contenido

Publicidad

1.3.6.3 Re-adjustment of oil pressure regulator

It is possible that after the compressor has been installed, the lubrication oil pres-
sure regulator needs to be re-adjusted.
This lubricating oil pressure regulator is factory preset and installed.
Fig.12
Re-adjustment procedure:
i.
ii.
iii.
iv.
v.
1.3.7
Verificación del sentido de rotación del eje motor
1
0089505esp_Pre-release_8
22.03.2017
1
Run the compressor untill the crankcase oil is at its stable operating tempera-
ture:
i.1
The lubricating oil pressure difference should be according to Sec-
ción 1.3.6.2, Página 26.
i.2
After the initial run the oil pressure difference should be slightly higher.
Determine the oil pressure difference (difference between the oil pressure
gauge and the suction pressure gauge).
Remove the cap nut of oil pressure regulator if the pressure needs to be re-
-adjusted.
Turn the slotted pin with a screwdriver clockwise or counter clockwise for a
higher or lower oil pressure respectively, until the required lubricating oil pres-
sure difference has been achieved.
Replace cap nut and sealing ring.
El regulador de presión del aceite se ajusta durante el funcionamiento, pero es posible que este ajuste se
deba corregir durante el funcionamiento inicial y también si el valor es <1,5 o >2,5 bar. El procedimiento
de reajuste aparece en la sección Reajuste del regulador de presión del aceite.
INSTALACIÓN Y PREPARACIÓN PARA EL USO
PREPARATIVOS PARA EL USO
Lubricating oil pressure regulator
27

Publicidad

Tabla de contenido
loading

Tabla de contenido