Mettler Toledo IND570 Manual De Instalación página 94

ControlNet network connections are made by using taps and drop cables from the main trunk line.
Figure 2-109 shows examples of two different ControlNet tap and drop cables. Note that the
connector may be straight or right-angled, as seen here. Either can be used with the ControlNet
interface installed in a panel mount IND570. This drop cable is not supplied by METTLER TOLEDO.
30205319 | 11 | 07/2019
RJ-45 for
diagnostics
and
configuration
Channel A
Figure 2-108: ControlNet PLC Module Connections and Components
Do not plug an Ethernet cable into the RJ-45 connector shown at left in Figure 2-108. This
connection is not used.
Straight
connector
Figure 2-109: ControlNet Tap and Drop Cables
Channel B
MAC ID switches (not used)
METTLER TOLEDO IND570 Terminal Installation Manual
LEDs
Right angle
connector
2-61