3.3.11 Output To Eco Vs Pump; 3.3.12 Display Wall Assembly; Pressure Switch; Design Without Display (Badu Omni Actuator) - Speck BADU OmniTronic Traducción De Las Instrucciones Para El Manejo Originales

Description

3.3.11 Output to Eco VS pump

The connection for the pumps BADU Eco VS, BADU Eco Touch-
Pro II and BADU Eco Soft is to be carried out as in the connection
diagram in point 5.3. The terminals correspond to the colours of
the pump's cables. BADU pumps may only be connected via the
control cable. The plug with network cable is to be plugged in to a
separate plug socket. With the VS pump, the digital inputs are to
be turned on: di = on.

3.3.12 Display wall assembly

This accessory is optionally available i.e. for restricted installation
conditions. The circuit board is placed in a separately prepared
box and connected to the BADU OmniTronic via a special cable
(approx. 2 m). The keypad and display are then easily reached on
the wall (article no. 260.6000.001)
3.4

Pressure switch

The pressure switch must be set to the pressure at which a
backwash cycle should be triggered. This value must be higher
than the filter's operating pressure.
In doing so, the pressure switch's terminal points 2 and 3 are
occupied.
Fig. 2
3.5

Design without display (BADU Omni actuator)

An actuator is offered for special applications. This is designed for
applications with superior technology systems. The actuator has
neither keys nor a display. The digital inputs are assigned to the
valve's six individual positions. There is a response when the
position has been reached (article no. 260.6100.041/51).
22 EN
2
3
26.1.072.1
05|2018