Installation; Installation Site; There Must Be Ground Drainage; Ventilation And Aeration - Speck BADU OmniTronic Traducción De Las Instrucciones Para El Manejo Originales

Installation

5 Installation
5.1

Installation site

5.1.1 Installation
• The BADU OmniTronic's installation site must be clean and
dry. Installation outdoors is not permitted.
• The BADU OmniTronic should be installed horizontally. Other
installation positions are not intended and must be cleared by
the sales team.
5.1.2

There must be ground drainage

 Calculate the size of the ground drain according to the
following criteria:
– Size of the swimming pool.
– Circulation flow rate.
5.1.3

Ventilation and aeration

 Ensure sufficient ventilation and aeration. The ventilation and
aeration must ensure the following conditions:
– Prevention of condensation.
– Limitation of the ambient temperature to maximum 40 °C.
5.1.4

Reserve space

 Measure reserve space so that the upper part of the BADU
OmniTronic can be removed and the clock can be set without
any trouble. Observe a removal height of 200 mm.
5.2 Installation
The BADU OmniTronic can be installed above or below the water
level.
For installation below the water level, observe the following points:
• If the BADU OmniTronic is installed between 1 m and 3 m
below the water level, a spring loaded SPECK non-return
valve must be installed (a).
• Installation at 3 m to 6 m below the water level should be
avoided. Deeper than 6 m is not permitted.
• Either a spring loaded SPECK non-return valve (article no.
240.9102.063) or an assembly bow to the water level must
be installed in the sewage line (b).
24 EN 05|2018