Faults/Troubleshooting; Overview - Speck BADU OmniTronic Traducción De Las Instrucciones Para El Manejo Originales

Faults/troubleshooting

7 Faults/troubleshooting
7.1

Overview

Fault: Leak found in pipe to sewer (inspection glass on valve).
Possible causes
Impurities in valve (sand) or on
the seal.
Fault: Leak found in pipe to sewer in the FILTER position
(inspection glass on valve).
Possible causes
Misalignment of the cam disc
e.g. due to jamming (seal
broken).
Fault: The backwash/rinse cycle cannot be started via the right-
hand key on the display.
Possible causes
Key not pressed long enough.
32 EN
Remedy
 Backwash in order to
remove any dirt from the
seal.
 Start a test cycle by
turning the red rocker
switch on and off.
 Send the actuator and
valve lid to the
manufacturer.
Remedy
 Send the actuator and
valve lid to the
manufacturer.
Remedy
 Press the right-hand key
on the display for more
than 3 seconds.
05|2018