Fan Housing Removal; Fan Wheel Replacement; Burner Components - L.B.White Foreman CI230 Manual Del Usuario E Instrucciones

4. Removed the four bolts using a 1/2 inch open ended
wrench.
■ Ensure motor and fan pulleys are properly aligned
when reinstalling.
■ Motor bearings are permanently lubricated.

Fan Housing Removal

1. Remove fan belt. See belt replacement procedure.
2. Remove fan motor. See fan motor section.
3. Locate and remove the four bolts at the base of the
fan housing. See below.
4. Locate and remove the eight sheet metal screws.
See drawing below.
5. Pull fan wheel housing out.
Foreman Ductable Oil Indirect-Fired Heater

Fan Wheel Replacement

1. Remove the fan belt. See Belt Replacement
2. Remove the fan shaft pulley. See Fan and Motor
3. Loosen all allen set screws on the fan shaft, including
4. Pull the fan shaft through the fan wheel and bearing
5. Lower the fan wheel to get access to the bearing
6. Remove fan housing ring screws.
7. Remove fan wheel.
NOTE: When installing new fan wheel, ensure the fan
wheel hub is on the same side as the motor pulley.

Burner Components

■ Never service heater while it is plugged in.
■ Allow the heater to cool before performing
■ Failure to follow this warning will result in burns
■ Do not attempt to install, repair, or service this
Screws
(4 per side)
Bolts
(2 per side)
Owner's Manual • Foreman
Procedures.
Pulleys Procedures.
the set screw on the fan wheel hub.
mount brackets.
mount bracket nuts behind the fan housing side.
WARNING
Burn or Fire Hazard
service, maintenance, or cleaning.
causing injury.
heater unless you have continuing expert train-
ing and knowledge of liquid fuel heaters
Ignition
Transformer Coils
19
Cad Cell