Conveyor Installation - Middleby Marshall PS536 Manual De Instrucciones

C.

Conveyor Installation

PS536 ovens may be equipped with either of two different
conveyor designs. Both designs are available in single belt and
split belt configurations. Refer to Figures 2-9 and 2-10 to
determine which conveyor was shipped with your oven.
Some conveyors MAY be
equipped with external
bearings on drive shaft
Figure 2-9 - Identifying the Type 1 conveyor
Pins on frame
fit into slots
on bracket
Figure 2-10 - Identifying the Type 2 conveyor
Hinge plates at
center of conveyor
frame
Conveyor frame made of
"C"-section stainless steel
11
• If your oven uses the Type 1 Conveyor, continue on to Step
1 in this section, "Type 1 Conveyor Installation."
• If your oven uses the Type 2 Conveyor, skip ahead to Step
2 in this section, "Type 2 Conveyor Installation."
Tensioning screws
(2 per side)
Conveyor frame made of
rectangular steel sections
Tension adjustment
screws (2) on idler
end of conveyor
SECTION 2 - INSTALLATION