Technical Specifications; Safety - PLYMOVENT EDS Instrucciones Para El Uso

L
K
J I
H
Fig. 2.1: Main components and elements
2.2 Operation
The air containing welding fume is being extracted through the
air inlet module on top of the unit. The larger particles and any
sparks are separated by a labyrinth-shaped spark arrester.
Subsequently the air is cleaned by the main filter cartridges. The
air subsequently passes the extraction fan and a duct silencer.
The clean air is blown back into the workshop by the outlet unit
with adjustable nozzles.
The unit contains the RoboCleanPlus system for automatic
sectionwise cleaning of the filter cartridges by compressed air.
The dust and dirt particles end up in the drum underneath.
Apart form air cleaning the system optimises the present natural
ventilation (draught) and/or forced ventilation (roof/wall fans)
system and equally distributes the present welding fume to
reduce the background concentration of welding fume in the
workshop.
3

SAFETY

General
The manufacturer does not accept any liability for damage to
the product or personal injury caused by ignoring of the safety
instructions in this manual, or by negligence during installation,
use, maintenance, and repair of the product mentioned on the
cover of this document and any corresponding accessories.
Specific working conditions or used accessories may require
additional safety instructions. Immediately contact your
supplier if you detect a potential danger when using the product.
0507340050/010111/D EDS
M
A
N
M
B
C
D
G F E
The user of the product is always fully responsible for
observing the local safety instructions and
regulations. Observe all applicable safety instructions
and regulations.
User manual
- Everyone working on or with the product, must be familiar
with the contents of this manual and must strictly observe the
instructions therein. The management should instruct the
personnel in accordance with the manual and observe all
instructions and directions given.
- Never change the order of the steps to perform.
- Always keep the manual with the product.
Pictograms and instructions on the product (if
present)
- The pictograms, warning and instructions attached to the
product are part of the safety features. They must not be
covered or removed and must be present and legible during
the entire life of the product.
- Immediately replace or repair damaged or illegible
pictograms, warnings and instructions.
Users
- The use of this product is exclusively reserved to well
authorised, trained and qualified users. Temporary personnel
and personnel in training can only use the product under
supervision and responsibility of skilled engineers.
- Use common sense. Stay alert and keep your attention to your
work. Do not use the product when you are under the
influence of drugs, alcohol or medicine.
- The product is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction.
- Children must be supervised not to play with the product.
1
Intended use
The product has been designed exclusively for extracting and
filtering harmful gases and particles which are released during
the most commom welding processes. Using the product for
other purposes is considered contrary to its intended use. The
manufacturer accepts no liability for any damage or injury
resulting from such use. The product has been built in
accordance with state-of-the-art standards and recognised
safety regulations. Only use this product when in technically
perfect condition in accordance with its intended use and the
instructions explained in the user manual.

Technical specifications

The specifications given in this manual must not be altered.
Modifications
Modification of (parts of) the product is not allowed.
Product combinations
If the product is used in combination with other products or
machines, the safety instructions in the documentation of these
products also apply.
1. "Intended use" as explained in EN-ISO 12100-1 is the use for which the technical
product is suited as specified by the manufacturer, inclusive of his directions in
the sales brochure. In case of doubt it is the use which can be deduced from the
construction, the model and the function of the technical product which is
considered normal use. Operating the machine within the limits of its intended
use also involves observing the instructions in the user manual.
EN - 15