Control Panel; Outlet Unit With Adjustable Nozzles - PLYMOVENT EDS Instrucciones Para El Uso

4.4.6 Silencer
To mount the silencer, proceed as follows.
Fig. 4.7
• Place a duct connector (C) in the outlet opening (D) of the
fan. Secure using 8 self-tapping screws.
• Place the other duct connector (A) on top of the silencer.
Secure using 8 self-tapping screws.
• Place the silencer (B) on the lower duct connector (C).
Secure using 8 self-tapping screws.
Fig. 4.7: Mounting of silencer

4.4.7 Outlet unit with adjustable nozzles

To mount the outlet unit, proceed as follows.
• Determine direction of outlet unit and airflow direction of the
individual nozzles.
Depending on the specific circumstances, it might be
necessary to partly or fully close one or more nozzles.
Fig. 4.8
• Place outlet unit (A) on duct (B). Secure with 4 self-tapping
screws.
• Place duct on silencer. Secure using 8 self-tapping screws.
Fig. 4.8: Outlet unit on duct
The duct should be fastened to the filter unit to strengthen the
configuration. Instead of fastening to the filter unit, the duct can
be attached to the wall as well.
To fasten the duct to the filter unit, proceed as follows.
0507340050/010111/D EDS
Fig. 4.9
•
•
•
A
B
A
B
Fig. 4.9: Fastening of duct
C

4.4.8 Control panel

The control panel can be mounted on any appropriate place. It
D
is recommended to mount the control panel on the side of the
fan housing.
Fig. 4.10
•
A
B
Fig. 4.10: Mounting of control panel
Mount the angle iron (B) on top of the air inlet module using
the supplied mounting material.
Fasten the duct to the air inlet module using the support
brackets and screw studs (A).
Make sure the duct and the filter base are parallel to each
other.
Mount the control panel (preferably) on the fan housing
using the supplied mounting material.
WARNING
Prevent exposure of control panel to welding or
grinding sparks.
EN - 19