Installation - Metra 99-5849CH Instrucciones De Instalación

Climate control panel
1. Connect the 16-pin harness with stripped leads into port A.
2. Connect the 14-pin harness with stripped leads into port B.
3. Connect the 5849 harness into port C, and then to the wiring harnesses in the vehicle.
These harnesses are the ones removed in Dash Disassembly, step 7.
4. Port D is a Micro-B USB input for updating the interface.
A
D
10

INSTALLATION

C
B
HVAC interface
5. Connect the HVAC interface harness into the HVAC interface, and then to the
wiring harnesses in the vehicle. These harnesses are the ones removed in
Dash Disassembly, step 4.
Attention! Disregard the 10-pin connector from the HVAC interface harness, it will not be
used in this application.
6. Connect the 4-pin flat to 4-pin stacked harness into the HVAC interface, and then to the
passenger airbag light assembly.
7. Connect the 6-pin harness from the 5849 harness to the HVAC interface.
8. For models with a 4.2-inch display screen: Connect the 12-pin backup camera harness
to the wiring harness in the vehicle. This harness is the one removed in
Dash Disassembly, step 5.
For models with an 8-inch display screen: Connect the female connector from the
54-pin backup camera harness to the wiring harness in the vehicle. This connector is
located behind the factory display screen, which was removed in Dash Disassembly, step 5.
Note: Disregard the male connector, it will not be used in this application.
9. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Use the antenna adapter provided to adapt the factory antenna connector
to the aftermarket radio.
|
1.800.221.0932 MetraOnline.com