INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Allows the override of the STOP/START engine feature
• The factory STOP/START button can resume the STOP/START feature
• Retains the factory backup camera
• Can be used in both amplified and non-amplified models (including Sony)
• Retains balance and fade (excluding Sony)
• Micro-B USB updatable
INTERFACE COMPONENTS
• Axxess interface (built into kit)
• 5849 harness
• HVAC interface
• HVAC interface harness
• 4-pin flat to 4-pin stacked harness
• 16-pin harness with stripped leads
• 14-pin harness with stripped leads
• 54-pin backup camera harness
• 12-pin backup camera harness
• Female 3.5mm connector with stripped leads
6
AXXESS INTERFACE INSTALLATION
TABLE OF CONTENTS
Backup camera harness ............................................................................................................ 9
Installation ...................................................................................................................................10
Programming ................................................................................................................................11
Configuration Menu ................................................................................................................ 12-14
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder, and heat shrink
• Tape • Wire cutter • Zip ties
Attention! This interface will work with models that are either Sony amplified, or non-
amplified. Please follow the instructions carefully for your model vehicle. Failure to do
so will result in either no sound, or low sound. If you are unsure if your vehicle is factory
amplified or not, please contact your local dealership.
|
1.800.221.0932
MetraOnline.com