Descargar Imprimir esta página

Starting The Engine; Electricstarter - Troy-Bilt Storm 2620 Manual Del Operador

Ocultar thumbs Ver también para Storm 2620:

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Starting the Engine
l_lhllL
ARNING!
Always keep hands and feet clear of
moving
parts. Do not use a pressurized
starting
fluid. Vapors are flammable.
NOTE:
Allow the engine
to warm up for a few minutes
after
starting.
The engine
will not develop
full power until it reaches
operating
temperatures.
ElectricStarter
WARNING!
The electric
starter is equipped
with a
grounded
three-wire
power cord and plug, and is
designed
to operate on 120 volt AC household
current. It must be used with a properly
grounded
three-prong
receptacle
at all times to avoid the
possibility
of electric
shock. Follow all instructions
carefully
prior to operating
the electric
starter.
DO NOT use electric
starter in rain.
1.
Determine
that your home's wiring
is a three-wire
grounded
system. Ask a licensed electrician
if you are
unsure. If you have a grounded
three-prong
receptacle,
proceed
as follows.
If you do not have the proper
house
wiring,
DO NOT use the electric
starter under any
conditions.
2.
Insert ignition
key fully into slot, Fig. 5-1. Make sure it snaps
into place. DO NOTturn
ignition
key. The engine cannot
start unless the key is inserted
into ignition
switch.
Figure 5-1
3.
Plug the extension
cord into the electric
outlet
located
on the engine.
Plug the other end of extension
cord into
a three-prong
120-volt, grounded,
AC outlet
in a well-
ventilated
area. See Fig. 5-2.
\
J
\/
Figure 5-2
4.
Move throttle
control to FAST (rabbit)
position.
5.
Move choke to the ON position
(cold engine
start). If engine
is warm, place choke in OFF position.
6.
Push primer three to five (3-5) times, making
sure to cover
vent hole when pushing.
If engine is warm, push primer
only once. Always cover vent hole when pushing.
Cool
weather
may require priming
to be repeated.
7.
Push starter button
to start engine. Once the engine
starts, immediately
release starter button.
Electric starter
is equipped
with thermal
overload
protection;
system will
temporarily
shut-down
to allow starter to cool if electric
starter becomes
overloaded.
8.
As the engine
warms, slowly rotate the choke control
to
OFF position.
If the engine falters, restart engine and run
with choke at half-choke
position
for a short period
of time,
and then slowly rotate the choke into OFF position.
9.
After engine
is running,
disconnect
power cord from
electric
starter. When disconnecting,
always unplug
the
end at the wall outlet
before unplugging
the opposite
end
from the engine.

Publicidad

loading