Trimmer Adjustment; Automatic Functions; Starting - DITEC GT Serie Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2
Selection of the
running direction
3
Anti-panic/continuity
with battery
4
Automation with
battery to the limit
of efficiency

3.3. Trimmer adjustment

FUNCTION
RP
Partial opening
RF
Power adjustment
VA
Opening speed
VC
Closing speed
TC
Automatic closing

3.4. Automatic functions

230 V~/BATTERY
BATTERY
OBSTACLE
RESET
POWER ALARM
COM

4. STARTING

WARNING:
-
Before carrying out any maintenance operations, always disconnect the power supply using the
external main switch and disconnect the battery from the electrical panel.
-
The power cable must be of the following type: 3x0,75 mm² HAR - H05VV - F.
-
An onnipolar switch with a contact aperture of a least 3 mm must be installed between the power supply
and the automation.
OFF
Control turns on powers the locker during the opening/closing operation.
(Locker is not normally powered).
ON
Select left opening for one-wing doors.
OFF
Select right opening for one-wing doors and working for two-wing doors.
ON
With main supply absence there is a continuous service with a buffer
battery.
OFF
With mains supply absence, with buffer battery, the door opens and
remains opened. Immediately also the battery releases from the panel.
ON
With the battery the door carries out the last opening operation.
OFF
With the battery the door carries out the last closing operation.
N.B:
Use only with DIP3 selected on ON
NOTE
This trimmer adjusts the passage spaciousness when the control is given
between 27-3A (3B). With the trimmer set to the minimum, the opening is equal
to 5% of the normal passage, with the trimmer set to the maximum the opening
is equal to 90% of the normal passage.
Adjustment of the motoring force. It adjusts in an inversely proportional way the
impact sensitivity against obstacles; more force corresponds to less sensitivity
and vice versa, a force adjustment inadequate to motion is considered an
obstacle.
This trimmer adjusts the opening speed.
This trimmer adjusts the closing speed.
It adjusts the time that intervenes between the ceased opening control and the
beginning of the automatic closing. The pause is adjustable from 0 to 30 seconds.
The passage from one to the other is automatic and immediate.
The electrical board of the automation keeps the battery in charge. The working
of the batteries starts AFTER that the 230 V power supply has stopped. It
stops when the voltage at the ends of the battery reaches 22 V after 30 s. The
batteries connected are dry type, with no servicing, 12 V 2 Ah each.
If the automation finds an obstacle during the closing run, it identifies and reopens
it. If it finds an obstacle during the opening run, it detects it and stops. The
working considers the obstacle the new stopping point. The research of the
effective opening or closing is automatic when the obstacle is removed.
The consequence of the power supply interruption, of the 1-29 reset control, is
a new acquisition from the automation. WARNING: during the acquisition phase
the safety controls, contact 1-8, are not active. The automation during the
acquisition works with a low speed therefore it is not dangerous. WARNING:
the reset does not affect the operating mode of the board, set via selector
COM96.
On with enabled automation. It flashes with fault in the board, the engine or the
encoder.
It allows the direct connecting with the COM96 electronic selector.
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

GteGtvGts-lGts-p

Tabla de contenido