Electrical Installation; Devicenet Connection - Lenze E94AYCDN Instrucciones Para El Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

6

Electrical installation

DeviceNet connection

To be able to communicate with the scanner and all other components, the Servo Drives
9400 must be assembled with communication modules.
A DeviceNet line can consist of a maximum of 64 nodes. Nodes are ...
ƒ the connected standard devices;
ƒ the scanner;
ƒ all other components taking part in communication.
Integrating the communication modules into the DeviceNet line requires a PC/laptop with
installed configuration software (e.g. »RSNetWorx«). The PC/laptop serves configuration
and diagnostics purposes only and therefore is no DeviceNet node.
)
Note!
Connect a bus terminating resistor of 120 W each to the first and the last
ƒ
node of the DeviceNet line.
Connect the shield at the voltage supply in conjunction with the "V−"
ƒ
connection to GND once. Select the centre point of the DeviceNet line if
possible.
The shield of the DeviceNet cable for each node must only be connected to
ƒ
the "SHIELD" port of the plug connector.
EDK94AYCDN DE/EN/FR/ES/IT 4.0
Electrical installation
l
DeviceNet connection
6
35

Publicidad

Tabla de contenido
loading

Tabla de contenido