Alpine DVA-9965 Manual De Operación página 64

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.
- The picture may be unclear, but this is normal.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor's fluorescent tube is worn out.
- Replace the monitor's fluorescent tube.
Image stops sometimes.
• Disc is scratched.
- Replace with a non-scratched disc.
Indication for CD Player
HI TEMP
• Protective circuit is activated due to high temperature.
- The indicaton will disappear when the temperature returns to
normal operating range.
NO DISC
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the c button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
ERROR
• Mechanism error.
1) Press the c button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
c button again.
If the error indication still does not turn off after pressing
the c button for a few times, consult your Alpine dealer.
• When "ERROR" is displayed:
If that the disc cannot be ejected by pressing c, press the RESET
switch (refer to page 8) and press c again.
If the disc still cannot be ejected, consult your Alpine dealer.
PROTECT
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
UNSUPPORT
• The disc is not written in a MP3/WMA supported format.
- Use a disc written at the MP3/WMA supported format.
62
-EN
Indication for DVD/Video CD Player
DISC ERROR
(Monitor display)
• Mechanism error.
1) Press c and eject the disc.
If the disc does not eject, press c again for at least 2
seconds and eject the disc.
If the disc still does not eject, consult your Alpine dealer.
2) When the error indication remains after ejecting, press c
again.
If the error indication still does not turn off after pressing
c a few times, consult your Alpine dealer.
NO DISC
(Monitor display)
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, "NO DISC" is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following step:
Press c again for at least 2 seconds.
(Monitor display)
• Remote control operation is not possible.
- For some discs or playing modes, certain operations are not
possible. This is not a malfunction.
REGIONAL CODE
VIOLATION
(Monitor display)
• Disc does not match regional code number.
- Load a disc that matches the regional code number.
HI-TEMP
(Monitor display)
• Protective circuit is activated at high temperature.
- The indicaton will disappear when the temperature returns to
normal operating range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
ERROR
(Audio display)
NO DISC
(Audio display)
ERROR
(Audio display)
HI TEMP
(Audio display)

Publicidad

Tabla de contenido
loading

Tabla de contenido