Ikegami IPD-Q38 Manual De Instrucciones página 17

S1: Put the cover into the hanger pipe from the ceiling
S2: Secure the joint metal with hanger pipe with supplied 3 screws.
S3: Connect leads and cables for the power and so on referring to the instruction.
S4: Insert three screws to the joint part of the upper section of camera until it makes free turn.
This is a temporary process.
S5: Put the top cover into the hanger pipe and insert the camera unit to the joint metal with the
indicated direction and then, turn it counter-clockwise lightly pushing upwards.
S6: Secure the camera unit with screws temporary used on S4 and fit the top cover with the
camera unit.
S7: Connect cables from the camera unit to the connectors on the board in the joint metal.
There are three cables to be connected.
Each contact point has different shape and size, so that you can simply find the right
connector.
S8: Pull down the cover until the joint metal is fully covered after pushing back sticking out
cables into the hanger pipe.
Be sure the dome cover is firmly secured without fail.
E-13