Pendant Type - Ikegami IPD-Q38 Manual De Instrucciones

3-2. Pendant Type

②
Inside the pipe
① Ethernet connector
For LAN cable connection.
Be sure to use Cat. (category) 5 or better LAN cable.
② Terminal Block
For signal In and Out connections.
The block is standard equipped with the power input (24V), audio output (AUD), microphone
input (MIC) and contact input (IN1) terminals. Three of the AUD, MIC, IN1, IN2, OUT1 and
OUT2 functions may also be optionally selected. You will be charged for customization.
For details, refer to "Basic Connection (p. 5)" or "System Connection (pp. 7-9)".
* This installation should be made by a qualified service person and should conform to all
local codes.
③ INIT switch
This is the switch to go back to the factory settings (Default), when failing loading of firmware.
(In such a case, Interface software will not go back and IP address should be reset again)
To go back to the factory settings (Default), the return software works only right after the
power ON, therefore, if you want to use this INIT switch for initializing, press and hold the INIT
switch and supply power. And keep pressing it for at least 10 seconds for initializing.
①
Without Top cover
E-4
③