Power On; Connect The Unit With Pc - Ikegami IPD-Q38 Manual De Instrucciones

10. Power On

Please note that this PTZ camera does not have a power switch and the power shall be applied
through power cable connection. About 10 seconds after applying the power, the Pan and Tilt
motors start to move to have the home position. The home position is the first place among other
99 pre-settable positions of the camera direction.

11. Connect the unit with PC

To make a direct connection with PC and the PTZ camera, use a cross-over type LAN cable.
The connection though HUB, a straight-through type LAN cable to use.
With the following screen, please input URL of this camera into the address bar of Internet
Explorer. The initial setting is "http://192.168.1.100".
A pop-up window opens, then, input an user name and password, and click . The initial
setting of those are "admin" for user name and "1" for password.
A user name and a password were correct, the following monitoring screen comes up.
The first time to connect a PC, the following massages of Security warning will appear on a
screen, then, click "Install". With this action the ActiveX is installed.
(This message will not appear in the second time afterwards)
E-18