Impecca ITAC-08KS Manual Del Usuario página 12

n° 1: eMeRson 15" Deep WAll sleeves
Wall Sleeve Brands:
4
3
4
2
4
8 8
3
4
#1 Emerson
1 . Remove existing rear grille as shown on page 9 of this
1. Remove existing rear grille as shown on Page
manual and replace with provided louvered rear panel .
11 of this manual and replace with provided
Install as shown here .
louvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
2. Attach(1)1 x3/8 x25 long seal in the center at
the top of the sleeve. Remove the backing paper
and press into position.
3. Attach the (2) 1 x3/8 x14 long seals to the
left and right sides of the sleeve.
4. Cut (2) 1 x3/8 x25 long seals to 14 long,and
attach it to the vertical sections of the rear grille
as shown.
1 / 1 /
5. Attach (2)4 x3
2 2
one on each side wall. Place in center of side
wall with the tapered end facing the opening.
6. Gently slide unit into sleeve.
7. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
8. Remove the plastic washer from the screw.
9. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
10.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
11 . Seal & frame the unit as described on p .20 . 11.Seal & Frame the unit as described on page 22.
12 . If you have difficulty with mounting the grill to the 12. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
sleeve, follow the instructions for direct mounting on p .19
mounting on Page 21.
12
10
15 Deep
x1 centering/support blocks
1 /
2