Impecca ITAC-08KS Manual Del Usuario página 20

n° 9: WHITe/WesTInGHoUse FRIGIDAIRe 22 " Deep WAll sleeves
Wall Sleeve Brands:
4
4
7
6
4
13
9
10
4
8 8
3
3
4
5
6
4
8
11
12
#9 White Westinghouse or Frigidaire
( 22 Deep)
1 . Remove existing rear grille as shown on page 9 of this
Remove existing rear grille as shown on Page
1.
manual and replace with provided louvered rear panel . 11 of this manual and replace with provided
louvered rear panel. Install as shown here.
Install as shown here .
NOTE: You may need to drill holes in flange
of existing sleeve to match new rear grille.
Because of the increased unit depth, first try
dry fitting using the method described below:
2. Place (2) 1 x1
1 /
2
3. Gently slide unit in and check if amount extend-
ing from the sleeve is sufficient once the trim
frame is attached.
4. If position is Ok, remove unit and proceed to
the next step. If not go to step 8.
5. Attach (1)1 x1 1 /
right sides of the sleeve.
6. Cut (1) 1 x1 1 / x25 long seal to 14 long and
2
attach it vertically to the rear grill 4.5 from
the left side ,repeat and attach 4 from the right
side.
7. Attach(1) 1 x1 1 /
2
the top of the sleeve.Remove the backing paper
and press into position.Proceed to step 14.
Use these next steps if the unit requires extra
extension into the room.
8. Attach 1 x / x14 long seal over the solid
3
4
vertical portion of the rear grille.
9. Attach (2) 4 x3
3 /
3 /
4
slot overlapping the seal above.
10. Install the divider into the slots of the foam
blocks. You may need to trim the length to size.
11. Repeat steps 8-10 for the other vertical shown
portion of the grille as shown in the picture.
12. Attach (2) 1 x1
of the sleeve again making sure all seals are
flush.
13.Cut the 1 x1 x25 seal to fit the top of the
1 /
2
sleeve. The pieces must be fitted flush to the
edge of the divider.
14. Center unit and gently slide unit into sleeve.
15. Before sliding all-the-way back, remove 1st
screw from front on left side of unit.
16. Remove the plastic washer from the screw.
17. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
18.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
19.Seal & Frame the unit as described on page 22.
19 . Seal & frame the unit as described on p .20 .
20. If you have difficulty with mounting the grill to
20 . If you have difficulty with mounting the grill to the
the sleeve, follow the instructions for direct
sleeve, follow the instructions for direct mounting on p .19
mounting on Page 21.
20
18
x14 seals against each side.
x15 long seal to the left and
2
x25 long seal in the center at
x1 foam blocks with the
3 /
4 4
x14 seals along the sides
1 /
2