Stopping The Engine - Ducati DTL7000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

to side.
Turn: The proper method of negotiating a turn
is to lower the handlebars to make the gravity
of tiller backward centre toward the rear and
then make the turn. This will permit a turn with
relative ease.
8) Normal Operating Angle
Lower the handle slightly so the front of the
machine is raised about 6-8º.
To get the maximum advantage from the tiller,
try to hold the machine at the angle shown
while you are tilling the ground.
CAUTION:
• Do not use the tiller with a rotor with
diameter over 300mm.
• Operating the tiller on grades could cause
the tiller to tip over .
• Allowing any one to operate this tiller without
proper instruction may result in injury.
• Wear sturdy, safety footwear
this tiller bare feet, or with open toe shoes or
sandals increases your risk of injury.
• Do not use the tiller in the night .
• Be sure to transport the tiller from one place
to another by two people, if a carrier is not
available.
• When the rotor is clogged with mud, pebble
etc, immediately stop the engine and clean
the rotor in a safe place. Be sure to wear
heavy gloves when cleaning the rotor.
To prevent damage, check the tiller for any
signs of damage or other faults each time
when the tiller is used after it has been
operated.

5. STOPPING THE ENGINE

If in an emergent situation
Turn the engine switch to "OFF" .
In normal situation:
1) Release the clutch lever to DISENGAGED
position and let shift lever in neutral
position.
Engine switch
2) Move the throttle lever fully to the right.
3) Turn the engine switch to "OFF"
. Operating
4)
Turn the fuel valve to OFF.
OFF
English
Owner´s manual
OFF
Clutch lever
Disengaged
Throttle lever
Fuel valve
33

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido